//SET UP AND PACKDOWN
SET UP
1. Build both feet sections (they have end caps on, 4no)
2. Add the lower legs, they are shorter poles with 2 holes in one end, the two holes go at the feet end.
3. Add the side bars (no2), now both sides are assembled.
4. add the cross bar (no1) and now the frame will stand freely.
5. Put the lower cross bar (no3) through the panel, there's a pocket for this at the bottom of the panel.
6. Slip the material panel over the frame then connect the male/female L brackets on the lower cross bar then clip on to the upright frame (self explanatory).
7. Place the baffle (pipe insulation) in the catch tray, this will stop BB'S rolling out.
PACKDOWN
Personally, I leave my panels set up and just take the feet off when not in use, they're pretty much flat and can be stored easily in my garage or shed.
When I do pack them down I only half break them down.
1. Disconnect the lower cross bar but leave it in the panel with the L connectors attached.
2. slip the panel off and roll up with the lower crossbar.
3. disconnect the top crossbar (no 1) but leave the L connectors attached.
4. disconnect the side bars (no2)
5. Disconnect lower legs leaving the top T connectors in.
6. Leave the feet as they are with T connector in place.
7. with a bit of jiggling the panels will pack down in to the bags this way making setup and pack down easier and quicker in future.
Email Support